Help › Using your own receiver
Using your own ADS-B receiver
A receiver is a small radio that hears aircraft near you directly. Tailwatch reads it over your home network every 1.5 seconds, with no daily limit, and uses adsb.lol only for aircraft it can't hear.
Already have one?
- In Tailwatch, open Settings → Data and turn on Use my ADS-B receiver.
- Type its name or address, like
adsb-feeder.local,piaware.localor192.168.1.50. - Click Test Connection.
Tailwatch finds the aircraft data on the usual paths for readsb, tar1090, dump1090 and PiAware. The first time, macOS may ask to let Tailwatch find devices on your network: choose Allow.
If the test can't find it, open the receiver's own map in a browser on the same Mac. If that works, type the same address into Tailwatch.
Build one
A receiver costs roughly $100 in parts and takes an evening.
Parts
| Part | Notes |
|---|---|
| Raspberry Pi | A Pi 4 or Pi 5 has plenty of power. A Pi 3B+ or Zero 2 W also works. |
| SDR radio | A USB stick made for 1090 MHz, such as the FlightAware Pro Stick Plus, which has a built-in filter and amplifier. |
| 1090 MHz antenna | A purpose-made ADS-B antenna, with the right cable for your radio (usually SMA). |
| Power supply | The official supply for your Pi model. Weak supplies cause odd failures. |
| microSD card | 16 GB or more, from a known brand. |
Set it up with adsb.im
adsb.im is a free, ready-made system image that needs no command line.
- Download the adsb.im image for your Pi and write it to the SD card with Raspberry Pi Imager.
- Put the card in the Pi, plug in the radio and antenna, connect it to your network, and power it on.
- From your Mac, open
http://adsb-feeder.localin a browser and follow the setup page: your location, and which networks to share with. - To qualify for an adsb.lol feeder key, turn on sharing with adsb.lol. See Data sources and limits.
- When the receiver's map shows aircraft, connect Tailwatch as described above.
PiAware (FlightAware's image) and a plain readsb or dump1090 install work the same way with Tailwatch.
Antenna placement
- Height and a clear view of the sky matter most. ADS-B is line of sight. A window is fine to start; an attic is better; outdoors above the roofline is best.
- Keep the cable short. Signal is lost in every foot of cable at 1090 MHz. Put the Pi near the antenna and run the network or power the longer distance.
- Keep it away from other electronics and metal screens, which block or add noise.
- Mount it vertically. ADS-B signals are vertically polarized.
A well-placed antenna hears aircraft 100 to 250 miles away at altitude. Low helicopters need a clear view toward them.
What changes in Tailwatch
- Watched aircraft your receiver hears update every second or two.
- Those aircraft stop using your adsb.lol allowance.
- Aircraft out of your receiver's range still come from adsb.lol.